Battery Charging (see figure B)

Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery of cordless worklight.

Note: The battery is supplied partially charged. To ensure full battery capacity, fully charge the battery in the charger before using your tool for the first time.

The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the charging process does not damage the battery.

The lithium-ion battery is protected against deep discharge by the "Electronic Cell Protection (ECP)". A protective circuit switches the cordless worklight off when the battery is drained.

Do not continue to press the on/off switch after the worklight has been automatically switched off. This can damage the battery. Ensure that the battery is charged and that the cordless worklight has cooled down before switching the cordless worklight on again.

To remove the battery (14), press the release button (13) and pull the battery out of the cordless worklight. Do not use force to do this.

Follow the instructions on correct disposal.