Start-up

Unlock the locking mechanism of the battery cover (2) and fold up the battery cover (3).

Insert the charged battery (14) into the lamp head (4) until you feel it engage and it is flush with the lamp head (4).

Close the battery cover (3) and then the locking mechanism of the battery cover (2).

  • Make sure that the rubber lip is seated correctly when closing the battery cover. Otherwise protection against dust and splash water will not be ensured.

Carefully fold out the stand (5) and place the cordless worklight on the floor. Make sure it is secure.

You can use the tripod mount (7) to screw the cordless worklight onto a tripod.

Tighten the 5/8" screw. Ensure that the tripod has a firm footing.

The lamp head (4) is attached to the carrying handle (8). The lamp head can be set to five different positions using the carrying handle.

To start up the cordless worklight, press the on/off switch (1).

To switch off the cordless worklight, press the on/off switch (1) again.

Press the on/off switch (1) briefly to switch on the cordless worklight with maximum brightness. To adjust the brightness in two stages, hold down the on/off switch (1) until the required brightness is reached.

When the permitted operating temperature is exceeded, the cordless worklight initially reduces the brightness before switching itself off if required for protection. Let the cordless worklight cool down and then switch the cordless worklight back on.

  • Make sure that the battery compartment (12) is not damaged when removing the coin cell.
  • Make sure that the positive pole of the coin cell faces upwards.

A warning will be displayed in the app before the coin cell (11) is fully used up.

To change the coin cell (11), unlock the locking mechanism of the battery cover (2) and fold back the battery cover (3).

Unscrew the screw of the battery compartment cover (9) and remove the battery compartment cover (10).

Remove the empty coin cell and insert a new coin cell.

Reattach the battery compartment cover with the screw.

The green LEDs on the battery charge indicator indicate the state of charge of the battery. For reasons of safety, it is only possible to query the state of charge when the cordless worklight is switched off.

Press the button for the battery charge indicator or to show the state of charge. This is also possible when the battery is removed.

If no LED lights up after pressing the button for the battery charge indicator, then the battery is defective and must be replaced.

Battery model GBA 18V...

LEDs

Capacity

3× continuous green light

60−100 %

2× continuous green light

30−60 %

1× continuous green light

5−30 %

1× flashing green light

0−5 %

 

Battery model ProCORE18V...

LEDs

Capacity

5× continuous green light

80−100 %

4× continuous green light

60−80 %

3× continuous green light

40−60 %

2× continuous green light

20−40 %

1× continuous green light

5−20 %

1× flashing green light

0−5 %