User interface
The user interface (3) is used as follows:
- To display the status of the pump
- To control the timer function
- To switch ECO mode on/off
When the pump is switched off, you can activate the user interface (3) by pressing the timer button (6) or the ECO mode button (11). This does not start the pumping process. You can now adjust settings on the user interface.
30 seconds after the last button is pressed or after the pump is switched off, the user interface (3) switches off and the settings (e.g. ECO mode) are saved.
The saved settings are deleted five minutes after the last button is pressed or after the pump is switched off. When the battery is removed, all settings are immediately deleted.
Status bar (9) | Low battery indicator (10) | Meaning |
|---|---|---|
Green | − | Pump is switched on, battery capacity > 20%. |
Orange | Orange | Battery low (1–20% capacity) |
Orange | − | Battery or pump is too warm. |
Red | Red | Battery empty (0–1% capacity), pump will switch off shortly. |
Red | − | Battery or pump overheated; impeller blocked; motor or battery faulty |
The pump can be switched off automatically using the timer function.
Press the timer button (6) repeatedly until the required remaining operating time (in minutes) is shown on the timer indicator (7). If the pumping process has started, the timer indicator (7) flashes and shows the remaining operating time.
To stop the timer function early, press the timer button (6) repeatedly until the field in the timer indicator (7) no longer lights up.