Starting Operation

A very large rechargeable battery will prevent the battery cover (5) from closing. In this case, the battery cover can be removed.

Push the two hinges inwards against the spring force. Remove the battery cover. There is no IP protection whilst the battery cover is not in place!

To refit the battery cover, push the two hinges inwards against the spring force again. Place the battery cover on the housing. Allow the two hinge pins to engage in the openings on the housing.

Place the worklight on a stable, level surface. Make sure it is secure.

The notched carrying handle (3) can be used to hang up the light. Make sure it is hung up securely.

You can use the tripod mount (4) to screw the worklight onto a tripod.

Tighten the 1/4" screw. Ensure that the tripod has a firm footing.

On/off switch

Function

Press 1×

Switches on the worklight, dimmed

Press 2×

Switches on the worklight, full brightness

Press 3×

Switches off the worklight

If the worklight has been dimmed for approx. 5 minutes, it is switched off immediately with the next press.

If the permissible operating temperature is exceeded, the brightness is first reduced before the worklight switches off for protection if necessary. Allow the worklight to cool down and switch the worklight on again.