Start-up

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Setting the cutting depth

Using the knob (2), the cutting depth can be continuously adjusted between 0–2.0 mm with the aid of the cutting depth scale (1) (scale division = 0.1 mm).

Switching on/off

Make sure that you are able to press the On/Off switch without releasing the handle.

To start the power tool, first press the lock-off switch (4), then press and hold the on/off switch (5).

To switch off the power tool, release the on/off switch (5).

Note: For safety reasons, the on/off switch (5) cannot be locked; it must remain pressed during the entire operation.