User interface
The user interface (6) is used as follows:
- As a status indicator for the dust extractor
- For establishing a connection to an Auto-Start Remote GCT … (39)
Status bar | Auto-Start function indicatorA) | Air flow alarm indicator | Meaning |
|---|---|---|---|
Green | − | − | Dust extractor is switched on and ready to use. |
Green | Green | − | Dust extractor is ready to use and connected to an Auto-Start Remote. |
Yellow | − | − | Battery almost empty |
Yellow | Yellow | − | No Auto-Start Remote found |
Yellow | − | Flashing yellow | Air Flow Alarm |
Red | − | − | Rechargeable battery empty, restart protection triggered or temperature alarm for dust extractor or rechargeable battery |
Slowly flashing blue | Slowly flashing blue | − | Connection to the Auto-Start Remote is automatically being re-established, following a switch-on of the Auto-Start function. |
Rapidly flashing blue | 1× flashing blue | − | Connection to the Auto-Start Remote is being sought and newly established. |
Illuminated blue (2 s) | Illuminated blue (2 s) | − | Connection to the Auto-Start Remote has been successfully established |
4× flashing blue (interval of 1.5 s) | − | − | Reset is being initiated. |
- A)
The Auto-Start function indicator (4) only lights up if the on/off switch (14) is in the
position.
To be able to use the Auto-Start function, the dust extractor must be connected via Bluetooth® to an Auto-Start Remote GCT … (39).
For this, the dust extractor and the Auto-Start Remote must be located in the immediate vicinity of one another.
If the on/off switch (14) of the dust extractor is turned to the position, the dust extractor automatically begins searching for an Auto-Start Remote GCT …. The statusbar (2) and the Auto-Start function indicator (4) slowly flash blue.
Reconnection to a known Auto-Start Remote:
If the dust extractor has already been connected to an Auto-Start Remote GCT … and this Auto-Start Remote is functional and within range, the connection to this Auto-Start Remote is automatically re-established.
Establishment of a new connection (first-time connection or connection to another Auto-Start Remote):
- Press and hold the pairing button (5) on the dust extractor until the statusbar (2) begins rapidly flashing blue.
- Then promptly press and hold the start/stop button (41) on the Auto-Start Remote (39) until the status indicator (40) on the Auto-Start Remote flashes blue twice.
Connection successfully established:
- The statusbar (2) and the Auto-Start function indicator (4) on the dust extractor light up green.
- The status indicator (40) on the Auto-Start Remote flashes green once.
Connection could not be established (after several minutes):
- The statusbar (2) and the Auto-Start function indicator (4) on the dust extractor light up yellow.
- The status indicator (40) on the Auto-Start Remote lights up red.
When the dust extractor is switched off, the connection to the Auto-Start Remote GCT … is saved. After it has been switched on again, the dust extractor attempts to re-establish connection to the same Auto-Start Remote automatically.